如何將micoach恢復到原廠設定值步驟:
1) Turn on the Pacer by moving the mode switch to “Free Run”
請把Pacer打開並且轉換至”Free Run”
2) Press and hold the “update” button in the middle of the Pacer
並按住中間最大的按鈕
3) While continuing to hold down the update button, insert a paper clip into the small reset hole on the back of the Pacer, at the lower left side. Press and release the reset button with the paper clip.
當持續按住中間的按鈕的同時, 請使用細微迴紋針按下Pacer後面左下方的細小孔 --自動回復鍵，按下之後再放開
按住中間按鈕後拿別針(因為孔很小)按小孔一次，此時不要鬆
開按住中間按鈕直到開始閃燈就可以不用按了
4) At this point, the Power indicator should turn off and then back on, indicating a reset
在這同時, 電源應該會關閉的, 之後會自動開啟並進行重新設定
5) Continue holding down the update button for 10 seconds
持續按住最大的按鈕達十秒鐘
6) After about 10 seconds, all three LED indicators (the power indicator, stride sensor indicator, and heart rate monitor indicator) should start blinking green in a sequential order around the update button in the middle of the Pacer
過了大約十秒之後, 全部的燈號(總電源, 步伐與心跳)會該開始
閃綠色
7) Once the lights start blinking around, you can release the Update button.
只要燈光開始閃爍時就可以不用按住中間的按鈕
8) In a few moments, all the LEDs will turn off
過了一陣子之後, 全部的燈就會熄掉
9) Then, the Stride Sensor (shoe) LED and Heart Rate Monitor (heart) LED will blink red, indicating a firmware downgrade
這時顯示步伐的燈和心跳的燈會閃紅色的, 並且會恢復到原廠設定
10) The following light sequence follows:
a. Stride sensor (shoe) LED is steady red.
b. Heart Rate Monitor (heart) LED blinks red.
c. Then both SS (shoe) LED and HRM (heart) LED turn off.
d. Main Power LED flashes Red.
e. Main Power LED flashes green and becomes steady green
接下來燈號會有以下步驟:
a. 顯示步伐的燈維持紅色
b. 顯示心跳的燈維持紅色
c. 然後兩個燈號會熄滅
d. 主電源燈開始閃紅色
e. 主電源燈開始閃綠色並且維持綠色
11) Pacer comes back on. You will not hear anything on the Pacer, except for perhaps static or a few beeps.
此時表示Pacer已經完成重新設定而且不會聽到任何聲音, 除了一些可能發生的靜電聲或畢畢聲
12) Try synchronizing again to download the firmware, the Manager and your workout definitions
重新與電腦同步並且下載自己的資料
停擺五天終於恢復正常了感謝jess寄來設並步驟，又學到一樣重設
原廠值方法很珍貴~~
留言列表
